Anolis Robin MiniMe Wireless DMX Especificações descarregar pdf (Página 25)

8. Error and information messages

DMX address blinks

It means that no DMX signal is received. Check DMX connectors and cables, check connection between the

xture and the control desk.

Note of exclamation at sign "Art"

It means that no ArtNet signal is received. Check RJ 45 connectors and cables, check connection between the

xture and the control desk.

Tilt Err

This message will appear after the reset of the xture if the head´s magnetic-indexing circuit malfunctions (sen-

sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head is not

located in the default position after the reset.

Pan Err

This message will appear after the reset of the xture if the head´s magnetic-indexing circuit malfunctions (sen-

sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head is not

located in the default position after the reset.

Focus Err

This message will appear after the reset of the xture if the focus module malfunctions (sensor failed or magnet

is missing) or the stepping motor is defective or its driving IC on the PCB.

Temp Err

This message informs you that head temperature exceeded 70°C and light source has been switched off.

InnCom Err

This message informs you that communication between Raspberry and a pan/tilt PCB is faulty.

Ethernet Err

This message informs you that some ethernet error has occured e.g. faulty network card.

Need Hw Upd

This message informs you that hardware update has to be performed.

Clear air Filt.

This message informs that the menu item remaining time ("R Ti ") in the menu "Information" is at 0 value. Clean

air lter and reset this counter.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 40 41

Sem comentários

Anolis Robin MiniMe Wireless DMX Especificações Página 25